Final Installation Part 3

For the last 4 Months I have been Finalizing the wiring

It takes awhile to fine tune wiring and make sure everything is connected properly

I went through 3 different Linear Actuators for the Reverse Switch

This is the 35 lb Progressive Automation Actuator for Reverse Gear

Top down view with the Reverse switch mounted to turn on the light

 Side view of Reverse Gear Actuator

Parking Brake Progressive Automation 50 lb Linear Actuator

Mounted inline with the frame 

Under side view of Parking Brake

Underside view looking towards the front

Starter DEI Wrap and the Oil Temperature Sensor

Now that the Wiring is finished I am starting the dash and console configuration

Initial dash and center console mounting

I initially wanted to mount my 7" Reverse Camera Screen below the air vents with my radio mounted vertically but the radio is to wide to fit

Changed the radio to mount below the air vents

As you might have noticed above, I created a bracket for my 7" AEM Digital Dash

This is the second version, the wings on either side are for my 4.3" screens

They will hold 2 screens with 2 inputs, 1 is always on but the second is primary when active

Electrical Wiring

Pulled the Engine and Transaxle to start the Electrical Wiring

This is the Pro Shift shifter on the left and an Infinity Box Power Cell on the right

Engine closeout panels installed

On the right behind the panel is the Pro-Shift ECU and the LS3 ECU wiring harness

Power cables run through the tunnel in a 1" Schedule 40 pipe to protect them

 Passenger footbox back together

A/C wired into the Infinity Box

Front Infinity Box Power Cell and A/C Trinary switch wired

On the bottom and just to the right of the Trinary Switch is the Dual Fans connector

Brake and Clutch Pressure Switches wired to the Infinity Box Master Cell

The Clutch pressure switch is also wired to the Pro-Shift ECU as a safety switch

The Brake pressure switch is connected to the brake lights through the Master Cell

Final Wiring loom installed in the engine bay

Shifter and gear selector wire loom