For the last 4 Months I have been Finalizing the wiring
It takes awhile to fine tune wiring and make sure everything is connected properly
I went through 3 different Linear Actuators for the Reverse Switch
This is the 35 lb Progressive Automation Actuator for Reverse Gear
Top down view with the Reverse switch mounted to turn on the light
Side view of Reverse Gear Actuator
Parking Brake Progressive Automation 50 lb Linear Actuator
Mounted inline with the frame
Under side view of Parking Brake
Underside view looking towards the front
Starter DEI Wrap and the Oil Temperature Sensor
Now that the Wiring is finished I am starting the dash and console configuration
Initial dash and center console mounting
I initially wanted to mount my 7" Reverse Camera Screen below the air vents with my radio mounted vertically but the radio is to wide to fit
Changed the radio to mount below the air vents
As you might have noticed above, I created a bracket for my 7" AEM Digital Dash
This is the second version, the wings on either side are for my 4.3" screens
They will hold 2 screens with 2 inputs, 1 is always on but the second is primary when active
No comments:
Post a Comment